FujiFilm FinePix S5100 Service Manual page 50

4. Adjustment
<Step 6>
FinePix S5100/5500_W adjustment item select screen
0. [ R ]
1. [ F 9 ] : AF-Assist Light Adjustment
2. [ F 5 ] : Camera Adjustment
3. [ F 4 ] : CCD Defect Correction
4. [ F 6 ] : AF Adjustment
5. [ F 1 ] : Battery Voltage Adjustment
6. [ F 7 ] : Flash Adjustment
7. [ F11 ] : VIDEO Adjustment
8. [ F12 ] : End Setting
[ F 8 ] : Firmware Download
[ X ]
<Note>
(1) 'FXS5100/5500 W PC Soft Ver.1.00' at the bottom-right of the screen indicates the version number of the adjustment
software.
(2) After running firmware download, other adjustments may be required depending on the content of the download software.
In such cases, the items to be adjusted, and the sequence of adjustment, will be indicated separately.
(3) After starting the adjustment software and beginning communication with the camera, always run End Setting following
adjustment and before returning the camera to the customer. If the End Setting is not run, the PC will not recognize the
camera when the two are connected.
Reason: As the camera will remain in the Jig mode (repair mode), it will not be recognized with the normal camera drivers.
(4) When the adjustment is interrupted after the [X]:Restart key is pushed, it remains about the Jig mode.
50
: Flash memory reset
*Only use for when the MAIN PWB has been replaced.
[Execute this item only when
need to change the firmware.]
: Restart
FXS5100/5500 ADJ Software Ver.1.00
FinePix S5100/S5500 Service Manual
<Fig. 4-7-5>