FujiFilm FinePix S5100 Service Manual page 46

4. Adjustment
<Step 3>
Select the "EVR & Comm" tab ([1] in Fig. 4-6-3) in the
"Customize" dialog box that appears.
Set the "EVR" items ([2] in Fig. 8) as follows.
Item
etc (-V2) Check
LANC page Check
<Step 4>
Select the "Etc" tab ([1] in Fig. 4-6-4) in the "Customize"
dialog box that appears. Set the "Other" items ([2] in Fig. 4-6-
4) as follows.
Item
# of auto measure 0
Change mode Do not check
Use Japanese font Do not check
Don't show OK NG Check or Do not check
<Step 5>
Select the "Hardware" tab ([1] in Fig. 4-6-5) in the
"Customize" dialog box that appears.
Input the values for PI and P Board ([2] in Fig. 4-6-5).
PIO 0 10
PIO 1 11
Set the "Hardware" items ([3] in Fig. 4-6-5) as follows.
Item
Debug Mode Select [Default]
<Step 6>
Once the above settings have been made, click on "Apply"
([4] in Fig. 4-6-5) in the "Customize" dialog box to complete
setup.
This applies the setup, therefore setting is unnecessary from
the next time forward.
[Note]
If [Disable OKNG display] on the PC screen (Fig. 4-6-4) is
set to OFF, the PC screen displays [OK] if adjustment is
OK,and [NG] if adjustment is NG(either setting is OK).
46
Details
Details
12 14 16
13 15 17
Details
FinePix S5100/S5500 Service Manual
(2) (1)
<Fig. 4-6-3>
(2)
<Fig. 4-6-4>
(1)
<Fig. 4-6-5>
(2)
(3) (4)