FujiFilm FinePix S5100 Service Manual page 49

FinePix S5100/S5500 Service Manual
<Step 4>
FinePix S5100/5500 Jig Mode Setup Procedure
1). Open the battery cover.
2). Connect the Power Cable Jig with the camera.
3). Adjust the output current of the power supply to 3.0A or less.
4). Adjust the output voltage of the power supply
to 5.0+-0.02V.
5). Connect the USB cable with the camera and PC.
6). Switch-ON the camera power while pressing the shutter button.
7). Check that the LED at the under the viewfinder
is lights in green.
Press the [Enter] key after completing the procedure of (1)-(7).
—> The [Firmware version check] screen appears.
<Step 5>
FirmWare = 1.28
Vendor Name =FUJIFILM
Manufacturer =FUJIFILM
ProductName =FinePix
Device Type =CAMERA
SerialNo =Y-750^^^^^040707C0PX0000000001
Frame Work =1.00
Please download a new version if it is necessary
to download the firmware.
Advance to the adjustment item selection screen
when press the [Enter] Key of PC.
—> The [Adjustment Items Select] screen appears.
<Note>
(1) [F1] Battery Adjustment cannot be run unless the Power Cable Jig is used to supply power to the camera.
(2) When new MAIN PWB ASSY is replaced, MAIN PWB ASSY is automatically initialized. At that time, wait for one-two
minutes, and advance the adjustment according to the instruction of the adjustment software.
4. Adjustment
<Fig. 4-7-3>
<Fig. 4-7-4>
49