Assembling The Unit; Connecting Charger To Power Supply - Stihl HLA 65 Instruction Manual

English

Assembling the Unit

Mounting the loop handle
Only versions without telescoping shaft
7
8
2
3
6
9
Place the clamp (1) in the loop
N
handle (2) and position them both
against the shaft (5) between the
carrying ring (3) and handle
hose (4).
Position the clamp (6) against the
N
shaft.
Line up the holes.
N
Insert the screws (7) with
N
washers (8).
Fit the square nuts (9) and screw
N
home the screws.
16
Line up the loop handle.
N
Tighten down the screws firmly.
N
7
8
1
4
9
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
HLA 65, HLA 85
2
1