Fitting The Harness - Stihl HLA 65 Instruction Manual

English
1
2
Turn screw (2) slowly clockwise as
N
far as stop – the lever must move
freely to closed position. If not, the
clamping force is too high.
Close lever (1) and press it home as
N
far as stop – the clamping force is
too high if the lever does not locate
against the stop.
Check clamping force.
N
If clamping force is too low:
Carefully turn screw (2) clockwise a
N
1/4 turn at a time – this increases
the clamping force.
If clamping force is too high:
Carefully turn screw (2)
N
counterclockwise a 1/4 turn at a
time – this reduces the clamping
force.
22

Fitting the Harness

The type of harness is market-specific.
Shoulder Strap
Versions without telescoping shaft
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Versions with telescoping shaft
1
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attaching Machine to Harness
1
2
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
1
2
2
1
HLA 65, HLA 85