Assembly - Ariens 915013-1742 EZR Owner's/Operator's Manual

Stop and inspect equipment if you strike an object.
Repair, if necessary, before restarting.
Never make adjustments or repairs with the engine
running.
ALWAYS lower attachment when unit is parked or
stored.
Grass catcher components are subject to wear,
damage, and deterioration, which could expose moving
parts or allow objects to be thrown. Frequently check
components and replace with manufacturer's
recommended parts, when necessary.
Mower blades are sharp and can cut you. Wrap the
blade(s) or wear gloves, and use extra caution when
servicing them.
IMPORTANT: On multi-blade mowers, rotation of one
blade will cause all blades to rotate.
Check brake operation frequently. Adjust and service
as required.
AVOID ELECTRIC SHOCK. Do not reverse battery
connections.
To ensure safe and proper operation, all parts and
hardware must be tightened securely. Use the correct
tools to ensure proper tightness.
TO REMOVE TRACTOR FROM SKID
1. Remove all accessible loose parts from shipping
carton.
2. Remove top and sides of crate.
3. Remove shrink wrap and packing material.
4. Cut any banding material holding tractor to skid.
5. 40" and 42" Deck - Raise mower deck attachment
lift lever to its highest position.
48" Deck - Slide mower deck out from under
tractor and set aside.
6. Release parking brake by pushing lever down.
7. Open transmission dump valves by lifting the
dump valve knob and pulling rearward until the
expanded section of the rod comes through the
hole in the trailer hitch. Push the rod back down
to lock it into position.
Dump Valve Rod
Trailer Hitch
8. Carefully push the tractor from the skid to a level
area.
EXPLOSIVE GASES from battery can cause death or
serious injury. ALWAYS keep open flames, sparks, or
smoking materials away from batteries.
POISONOUS BATTERY FLUID contains sulfuric acid
and its contact with skin, eyes, or clothing can cause
severe chemical burns. ALWAYS wear safety glasses
and protective gear near battery.
DO NOT tip battery beyond a 30° angle in any
direction.
ALWAYS maintain unit in safe operating condition.
Damaged or worn muffler can cause fire or explosion.
Spark Arrester
This product is equipped with an internal combustion
engine. DO NOT use on or near any unimproved, forest
covered or brush covered land unless the exhaust
system is equipped with a spark arrester meeting
applicable local, state or federal laws. A spark arrester,
if used, must be maintained in effective working order
by the operator.

ASSEMBLY

9. 40" and 42" Deck - Remove banding holding
discharge chute up against tractor.
48" Deck - Install deck per the instructions in
Service and Adjustments .
ASSEMBLY
1. Check Levelness of Deck
Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting results.
(Tires must be properly inflated for leveling. See
Specifications. ) See Deck Leveling in Service and
Adjustments .
2. Check Battery
If the battery is put into service after the month
and year indicated on the battery, it must be
charged before use. With a 12 volt battery
charger, charge the battery for a minimum of one
hour and no more than two hours at a rate of 6 to
10 amps.
Remove battery from unit before servicing. See
Maintenance for specific information.
3. Check Engine Oil
This tractor has been filled with oil at the factory.
Verify engine oil level prior to starting engine and
add oil if required.
4. Adjust Seat
Adjust seat to a comfortable position and tighten
OE0301
securely. See Service and Adjustments .
GB - 10