Operating Method - EdgeStar IB450SSP Owner's Manual

EdgeStar Built-in Ice Maker
8. Has the power supply voltage been checked or tested against
the nameplate rating? And has proper grounding been installed
for the ice maker?
9. Is the ice maker plugged in?
10. Have you turned on the main water supply and the tap?
11. Have you checked for leaks at all water supply connections-
and at the drain?

Operating Method

1. Turn on the water tap, let the water trough fill, then find the control
panel and press the ON/OFF button. When the unit is powered on,
it will produce ice.
2. After three minutes, the machine will automatically go to the ice
making stage, and the sound of flowing water will be heard.
3. When the batch of ice has been fully formed, ice will automatically
be harvested to the ice storage bin.
4. When the ice storage bin is full, the sheet of cubes will not fall
completely and will hold the ice-full probe open. The machine
stops making ice and automatically progresses to the cold
preservation stage. During this stage, the compressor works
regularly to keep the temperature lower to reduce ice melting.
5. The unit will start making ice again after the ice cubes are
removed. At that time, the ice-full probe swings back to operating
position.
6. Internal LED light (If present): The internal LED light will be
controlled by a magnetic reed switch that is installed on the inside
of the door. It will turn On and Off automatically when the door
opens and closes, respectively.
7. Water Pump Drain system (when equipped): as soon as the melted
ice water or other surplus water in the reservoir reaches the
maximum level, the water level switch closes and transmits a low
voltage current to the circuit board. The circuit board activates the
water drain pump for 20 seconds, pumping out most of the water
contained in the reservoir.
10