Leveling The Ice Maker; Reversing The Door Swing - EdgeStar IB450SSP Owner's Manual

IMPORTANT: Before
you begin, unplug the
ice maker or disconnect
the power.
EdgeStar Built-in Ice Maker

Leveling the Ice Maker

It is important for the icemaker to be leveled in order to work
properly. It can be raised or lowered by rotating the plastic sheaths
around each of the four feet on the bottom of the machine .If you
find that the surface is not level, rotate the feet until the ice maker
becomes level .You may need to make several adjustments to level
it. We recommend using a carpenter's level to check the machine.
1. Place a carpenter's level on top of the product to see if the
ice maker is level from front to back and side to side.
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower.
Turn the leveling feet to the left to raise.
IMPORTANT: Once you are ready to install it in a cabinet or
directly on the floor, you must adjust the feet to level the ice maker.
If the floor is level, just revolve the two front feet to touch the floor.

Reversing the Door Swing

Tools needed: flathead screwdriver, Phillips screwdriver
Removing the door
1. Using a flathead screwdriver, separate the hinge axis
from hinge 1 (the top hinge). See picture on the following
page.
2. Remove the three screws securing the top hinge to the
cabinet. Place hinge, screws and hinge axis safely aside.
3. Open the door about 20 degrees, then lift the door off
hinge 2 (the bottom hinge) and set door aside.
4. Repeat step 2 for the bottom hinge.
Replacing the door
1. Rotate the door 180 degrees from its original position.
Note: the handle should be installed opposite the door
hinges.
2. Fasten the two hinges securely to the cabinet opposite
their original installed location. For example, the top left
hinge will now be the bottom right hinge. Reference the
diagram on the next page.
3. Install the hinge axis through the bottom supporting
hinge. Gently place the door on the supporting hinge.
The door should be open approximately 20 degrees.
4. Install the top hinge axis. Tighten firmly. Replace any
hinge covers, when applicable.
6