Operation; Final Check List Before Operation; Operating Method - EdgeStar IB450SSP Owner's Manual

Operation

Final Check List before Operation

1. Have all packing materials and tape been removed from the interior and exterior of the ice
maker?
2. Did you clean the ice storage bin?
3. Have the installation instructions been followed, including connecting the machine to water and
electricity? Does the unit have proper drainage?
4. Has the machine been leveled?
5. Is the ice maker in a site where the ambient temperature is between 50º F and 100º F and the
water temperature is between 41º F and 90º F all year round?
6. Has the water supply pressure been checked to ensure a minimum of 15 psig with a static
pressure not to exceed 80 psig?
7. Is there a clearance of at least 2" at the rear and
8. Has the power supply voltage been checked or tested against the nameplate rating? And has
proper grounding been installed for the ice maker?
9. Is the ice maker plugged in?
10. Have you turned on the main water supply and the tap?
11. Have you checked for leaks at all water supply connections and at the drain?

Operating Method

1. Turn on the water tap, let the water trough fill, then find the control panel and press the ON/OFF
button. When the unit is powered on, it will produce ice.
2. After three minutes, the machine will automatically go to the ice making stage, and the sound of
flowing water will be heard.
3. When the batch of ice has been fully formed, ice will automatically be harvested to the ice
storage bin.
4. When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the ice
slide down. The machine stops making ice automatically.
5. The unit will start making ice again after the ice cubes are removed. At that time, the ice slide will
swing back to operating position.
6. Internal LED light: The internal LED light will be controlled by a magnetic reed switch that is
installed on the inside of the door. It will turn On and Off automatically when the door opens and
closes, respectively.
7. Water Pump Drain system: as soon as the melted ice water or other surplus water in the
reservoir reaches the maximum level, the water level switch closes and transmits a low voltage
current to the circuit board. The circuit board activates the water drain pump for 20 seconds,
pumping out most of the water contained in the reservoir.
Important:
• Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of cubes must be discarded.
• Never turn the water supply tap off when the ice maker is working.
• Never touch the evaporator when the machine is running.
• Except to take ice from the unit, keep the door closed to reduce melting and ensure proper ice
formation.
" at the top and sides for proper air circulation?
1
/
4
11