Operating Instructions; Panel - Bosch Vision 500 Series Operating, Care And Installation Instructions Manual

OPERATING INSTRUCTIONS

Before using
d WARNING
To reduce the risk of fire, electric
shock, or injury to persons, read the
IMPORTANT SAFETY
INSTRUCTIONS before operating
this appliance.

Panel

A
Cycle Selector
Switches the machine on and off and
selects the program (see page 22). Can
be turned in both directions.
To switch off the dryer, rotate
the cycle selector to Off".
B LED Indicator Lights
LED'S light up in sequence to show the
current moisture state of the drying
process.
Wrinkle Block/Finished - at the end
of the drying cycle an acoustic signal
sounds and the Wrinkle Block/Finished
LED lights up. The drum rotates at
specific intervals for one hour to
prevent the laundry from creasing (see
page 23 ).
C Lint Filter LED
Blinks as a reminder to clean the lint
filter after use. Blinks for 10 seconds
when the door is opened after a cycle
ends, or in the event airflow is reduced
enough to create a CLn" or E:12"
error (see troubleshooting guide, page
30).
20
d
Before using your dryer, read and
follow all installation and operating
instructions.
A
D
Display
300 and 500 Series
LED countdown indicates the estimated remaining
time of a running cycle (in minutes).
800 Series
Indicates the settings of additional options and the
estimated remaining time of programs. (See page 25)
Additional Options
Menu selects one of the additional options
Select changes the settings of the selected option
E
Option buttons
Add functions to the cycle selected. The option button
LED is lit when the option is selected. Press the option
button again to turn the option off (LED turns off).
Delicates: Press for temperature-sensitive textiles
(e.g. acrylic fibers). The temperature of the drying
process is reduced, the drying time is extended
correspondingly.
ECO Action: Press for additional energy savings (use
only for cotton and permanent press cycles). Press the
option button prior to starting an automatic cycle.
WARNING
B D
C
E
G
F
F
Signal
300 and 500 Series
Press both option buttons at the same time
to enable the acoustic signal. When the
cycle is finished, an audible beeping tone
will be emitted (see page 22). Press both
buttons again to disable the signal.
800 Series
The 800 Series signal is set using the LCD
menu (see page 25).
G
Start/Pause Button
Starts, interrupts and ends the drying
process.
Start/Pause LED Status
Lit Red: Program is running and "Pause"
can be activated.
Blinking: Settings can be changed, the
drying cycle can be started, or program is
in Pause" mode.
Not Lit: Cycle is finished or there is no
cycle selected.