AT&T 8434 User Manual page 15

To program/reprogram an
outside number,
extension, or feature code
into a personal list
To place a call using a
personal, group, system,
or enhanced list
1 On a separate sheet of paper, jot down the outside
numbers, extensions, and/or feature codes you want to
program as items on your personal list(s) (see example
to the left)
Note: Each phone number or feature code is stored as
a separate item.
Pick up handset
2
Note: If you are using the built-in speakerphone, you
must press a call appearance button, before you
proceed to Step 3.
3
Press [ ]
Program
or Dial Program code
Dial Personal List number (1, 2, or 3)
4
Dial list item (1, 2, 3...)
5
Dial number you want to program (up to 24 digits)
6
Note: If you are programming an outside number, be
sure to include a trunk code, if applicable.
Press [ ]
7
#
Number is stored
Repeat Steps 5-7 if you want to program
additional items on the same list; press [
and begin again at Step 1 if you want to program
items on another list
Hang up to end programming
8
Note: Record your personal list items on the
Abbreviated Dialing list in the back of this booklet;
group, system, and enhanced lists can be obtained
from the System Manager.
Dial appropriate AD list code:
1
List 1
List 2
List 3
2 Dial desired list item (1, 2, 3...)
Call is dialed
Note: You can program a list code on one of your
AD buttons for faster access to a list. To place a call,
simply press the AD button and then dial the desired
list item.
[dial tone]
[dial tone]
[dial tone]
[dial tone]
[confirmation tone], [dial tone]
Drop Test
[dial tone]
[ringback tone]
]
11