Honda CB300FA Owner's Manual page 91

Installation
1.
Attach the side collars to the wheel.
2.
Position the wheel between the fork legs
and insert the front axle shaft from th e
left side, through the wheel hub and
right fork leg .
3. Tighten the front axle nut.
I
Torque: 44 lbf·ft (59 N·m, 6.0 kgf·m).
4. Instal l the brake caliper and tighten the
mounting bolts.
I
Torque: 22 lbf·ft (30 N·m, 3.1 kgf·m).
I
..... Ta ke ca re to prevent the brake ca liper
from scratch ing the wheel during
installation .
..... Use new mounting bolts when
insta lling the brake caliper.
Tire Puncture
~
Removing Wheels
lmlm
When installing the brake caliper into position on the
fork leg, carefully fit the brake disc between the pads
to avoid scratching them.
5. Lower the front wheel on the ground.
6. Apply the brake lever and pump the fork
several times.
7. Tighten the axle pinch bolt.
I
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m).
8.
Raise the front wheel off the ground
again, and check that the wheel rotates
freely after you release the brake .
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
•
contin ued
87