Cub Cadet RT 75 Shop Manual page 44

RT 75
1. Remove the tine hood end cover and the side
shield. See Figure 7.3.
2. Remove the tine assemblies by removing the clevis
pin and bow tie clip that secures the tine assemblies
to the tine shaft on the transmission.
See Figure 7.4.
NOTE: Replace the nut and bolt if they show signs
of wear or damage.
3. Slide the assemblies off of the tine shaft.
NOTE: If the hub assemblies are frozen to the tine
shaft, a hub puller can be used to remove
them.
4. Remove the old tines from the tine assembly. with a
pair of 1/2" wrenches. See Figure 7.5.
40
Figure 7.3
bow tie clip
Clevis pin
Figure 7.4
1/2" wrenches
Figure 7.5