Reverse Drive Cable - Cub Cadet RT 75 Shop Manual

RT 75

Reverse drive cable

To remove the reverse drive cable:
1. Disconnect and ground the spark plug wire.
2. Disconnect the red cable fitting from the handle bar
bracket. See Figure 3.8.
3. Unhook the Z-fitting from the reverse drive lever.
4. Remove the two screws that secure the belt cover.
See Figure 3.9.
NOTE: The left screw has a washer to prevent the
slot in the cover from opening up as the screw
is tightened.
5. Swing the belt cover up and off of the tiller.
6. Slide the forward drive belt off of the engine pulley.
7. Slide the reverse belt off of the idler pulley.
7a. Loosen the nut and bolt that secures the idler
pulley to the idler bracket.
7b. Slide the belt past the belt guides.
8. Loosen, but do not remove, the screw securing the
cable pulley. See Figure 3.10.
14
Disconnect the
cable fitting
Figure 3.8
Remove these
screws
Figure 3.9
Z-fitting
Figure 3.10
Loosen this screw