To Manually Feed Nylon Line - Flymo STXT25 Original Instructions Manual

.To manually feed the nylon line (K)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed
button, whilst gently pulling on one of the lines until
the line reaches the line cutter.
3. When the required amount of line is fed out, gently
pull on the second line (there is no need to press
the manual line feed button again).
4. If the line extends past the line cutter, too much line
has been fed out.
5. If too much line is fed out, remove the spool cap
and click spool anti-clockwise until the line is at the
desired length.
To remove spool cap
1. Press and hold in the two cap release latches. (L).
2. Pull cap away from the spoolholder. (L).
When refitting the spool cap
1. Keep all areas of the cap and spoolholder clean.
Failure to do so may prevent the cap being se-
curely located in the spoolholder.
2. Replace the cap, pressing firmly DOWN towards the
spoolholder to ensure cap is fully located.
3. Check that the cap is correctly fitted by trying to re-
move it without depressing the two latches.
To replace nylon line.
For your convenience it is recommended you buy
spool and line complete. Nylon line only is also avail-
able. Both are available from Husqvarna UK Ltd.
stockists.
To fit spool and line complete:
1. Remove old spool.
2. Place new spool into spoolholder with cut out areas
of the spool in line with eyelets as shown in figure
M.
3. Release one line from cleat and feed line through
eyelet (M).
4. Repeat for second line.
• Ensure spool is fully located by gently rotating it
during fitment, whilst keeping the spoolholder
steady.
5. Refit the cap.
To fit nylon line only:
• Remember! Your Trimmer is designed to use only
nylon line with a maximum diameter of 1.5mm. Use
only genuine Husqvarna UK Ltd. nylon line.
1. IMPORTANT - Always wind the line onto the upper
section of the spool first.
Take approximately 5 metres of line. Insert 15mm
of line into one of the holes in the upper section of
the spool (N) and wind line in the direction of the
arrows on the top of the spool. Leave approxi-
mately 100mm of line unwound and place into cleat
as illustrated in figure N. Repeat on lower section
of spool.
2. Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will im-
pair the efficiency of the automatic line feed.
3. Then fit spool as described in 'To fit spool and line
complete', section above.
• Always return the product to its normal operating
position before switching on.
Automatic Line Feed System cont'
K
Manual line
feed button
L
Spool
Spoolholder
M
N
Cap
Cap release
latch
Eyelet
Cut out area
of spool
Eyelet
Cleat