Flymo STXT25 Original Instructions Manual page 3

General
1. This product is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given su-
pervision or instruction concerning the use of the
product by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the product. Local regulations
may restrict the age of the operator.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the trimmer in the manner and for the
functions described in these instructions.
5. Never operate the trimmer when you are tired, ill
or under the influence of alcohol, drugs or medi-
cine.
6. The operator or user is responsible for accidents
or hazards occurring to other people or their prop-
erty.
Electrical
AVOID ACCIDENTAL STARTING, REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN:- CLEANING AROUND THE
INSIDE OF THE SAFETY GUARD, REMOVING OR
REFITTING SPOOL CAP , MANUALLY FEEDING OR
REPLACING NYLON LINE
1. We recommend the use of a Residual Current
Device (R.C.D.) with a tripping current of not more
than 30mA. Even with a R.C.D. installed 100%
safety cannot be guaranteed and safe working
practice must be followed at all times. Check your
R.C.D . every time you use it.
2. Before use, examine the cable for signs of dam-
age or ageing. If the cable is found to be defec-
tive, take the product to an Authorised Service
Centre and have the cable replaced.
3. Do not use the trimmer if the electric cables are
damaged or worn.
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is dam-
aged. Do not touch the electric cable until the
electrical supply has been disconnected. Do not
repair a cut or damaged cable. Replace it with a
new one.
5. Your extension cable must be uncoiled, coiled ca-
bles can overheat and reduce the efficiency of
your trimmer.
6. Keep the cable clear of the cutting area and ob-
stacles at all times.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnect-
ing any plug, cable connector or extension cable.
9. Never pull on the cable to disconnect any of the
plugs.
10. Switch off, remove plug from mains and examine
electric supply cable for damage or ageing before
winding cable for storage. Do not repair a dam-
aged cable, replace it with a new one. Use only
our replacement cable.
11. Always wind cable carefully, avoiding kinking.
12. Use only on AC mains supply voltage shown on
the product rating label.
13. Our trimmers are double insulated to EN60335.
Under no circumstance should an earth be con-
nected to any part of the trimmer.
Preparation
1. While using your product always wear eye protec-
tion, substantial footwear and long trousers. Do not
operate the equipment when barefoot or wearing
open sandals.
2. Before using the machine and after any impact,
check for signs of wear or damage and repair as
necessary.
3. Inspect the area to be cut before each use. Re-
move all objects such as stones, broken glass,
nails, wire, string etc, which can be thrown or be-
come entangled in the trimmer head.
4 . Before use, inspect the area for wildlife, espe-
cially hedgehogs.
5 . Check that the cutting head is fitted correctly.
Use
1. Use the trimmer only in daylight or good artificial
light.
2. Avoid operating your trimmer in wet grass, where
feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and
wear non-slip footwear.
5. Do not walk backwards when trimming, you could
trip. Walk never run.
6. Keep cutting head below waist level.
7. Switch off before pushing the trimmer over sur-
faces other than grass.
8. Never operate the trimmer with damaged guards
or without guards in place.
9. Never fit metal cutting elements.
10. Keep hands and feet away from the cutting
means at all times and especially when switching
on the motor.
11. Never pick up or carry a trimmer by the cable.
12. Do not lean over the trimmer guard - objects may
be thrown by the cutting line.
13. Remove the plug from the mains :
- before leaving the trimmer unattended for any pe-
riod;
- before clearing a blockage;
- before checking, cleaning or working on the appli-
ance;
- if you hit an object. Do not use your trimmer until
you are sure that the entire trimmer is in a safe
operating condition;
- if the trimmer starts to vibrate abnormally. Check
immediately. Excessive vibration can cause in-
jury.
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be sure
the trimmer is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Only use the replacement cutting line specified
for this product.
4. Only use replacement parts and accessories rec-
ommended by Husqvarna UK Ltd.
5. After any maintenance in dealing with the cutting
line, always return the product to its normal oper-
ating position before switching on.
6. Clean unit with a dry cloth. Never use metal ob-
jects to clean the unit.
7. Inspect and maintain the trimmer regularly. Any
repairs must be carried out by an authorised re-
pairer.
8. Store in a cool dry place and out of reach of chil-
dren. Do not store outdoors.
9. Allow the product to cool for at least 30 minutes
before storing.