License Plate Lamp - Chevrolet Camaro 2016 Operating Manual

Base Taillamp
1. Back-up Lamp
2. Stop/Turn Signal
3. Taillamps
For the uplevel taillamp assembly,
only the backup bulb is replaceable.
Removal of the taillamp assembly is
not necessary to change this bulb.
To replace one of these bulbs:
1. Open the trunk. See
Trunk 0 38.
2. Remove three pushpin
fasteners and three 8mm nuts.
3. Firmly grasp the taillamp
assembly and pull it
straight out.
4. Turn the bulb socket
counterclockwise to remove it.
5. Pull the old bulb straight out of
the bulb socket.
6. Push the new bulb straight into
the bulb socket until it clicks.
7. Turn the bulb socket clockwise
to reinstall.
8. Push light assembly back into
place.
9. Install three pushpin fasteners
and three 8mm nuts.
Vehicle Care

License Plate Lamp

To replace one of these bulbs:
1. Unclip the license plate lamp
from the fascia opening.
2. Pull the license plate lamp
down through the fascia
opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the lamp
socket.
4. Install the new bulb.
5. Push the bulb straight into the
socket and turn clockwise to
reinstall.
277