Samsung SND-L6012 User Manual page 75

802.1x
When connecting network, you can choose whether using 802.1x protocol, and then install
the certification.
1. From the Setup menu, select the
<network ( )> tab.
2. Click <802.1x>.
3. Set the <ieee 802.1x setting>.
• IEEE 802.1x : Specify the use of the
802.1x protocol.
• EAP type : Select EAP-TLS or LEAP.
• EAPOL version : Select version 1 or 2.
• ID : Enter the client certificate ID in
EAP-TLS and the user ID in LEAP.
• Password : Enter the client private
key password in EAP-TLS and the user password in LEAP. You do not have to
enter the password in EAP-TLS if it uses a key file that is not encrypted.
If the connected network device does not support the 802.1x protocol, the protocol will not
`
J
operate properly even if you set it.
LEAP is an authentication method with poor security. Use it only in an environment where EAP-
`
TLS is not available.
4. Install/remove the certificate.
The certificate is needed only for EAP-TLS.
• CA certificates : Select a public certificate that contains the public key.
• Client certificate : Select a public certificate that contains the client certificate key.
• Client private Key : Select a public certificate that contains the client private key.
5. When done, click [apply (
to install/remove 802.1x related certificates
1. Press the [Browse (
2. If no certificate is installed, you will see "Not Available" appearing next to the selected
item.
3. Press the [install (
next to the item.
4. Press the [Delete (
)].
)] button for each item and select a certificate to install.
)] button to start installation with a message of "Installed"
)] button to remove the certificate.
English _75