Sony sl-hf600 Owner's Manual page 39

3
Continue the playback and at the end of the scene to
be recorded, press MARK button agaln.
Use the Betascan or Beta SkipScan function for
quick searching of the endlng polnt.
The endlna point will
4 Set the connected VCR to the recording pause mode.
(For details. read the inat~ction manual of the other
VCR.)
5
Press EDlT START button.
The tape on this VCR wlli be rewound to the starting
polnt you chose In step
2
and playback wlll begin,
and at the same tlme, the connected VCR will start
recording.
SL-HFBOO
Automatic start
and stop (pause)
of
playback
Connected
VCR
At the stopping point you chose in step
3,
this VCR will
be in the playback pause mode and the connected VCR
will be in the recording pause mode.
The
lamp on the EDl T
PLAY
button
will
bllnk.
To
the
same noording again, press the EDlT
START button again.
The preset startlng and endlng points may shlft
by
a small
amount
If
you repeat thls several times.
The tape transport buttons,
m, w,
44
and H, can be
used as usual after presetting the starting and ending
polnts. When the EDlT START buttton is pressed, the
playback and recording wlli be made as preset.
To p m e t another acme of the seme tape
By "Betascan" or by turning the
JOG
dlallSHUTTLE rlng
or slmply by releasing the pause mode wlth the I 1
(pause) button, play back the tape and repeat steps 2-5.
To stop the t a p durlng the heutomatlc assemble editing,
Press the (stop) button.
To put the VCR back to the normal ncordlnglplayback
mode
Press the EDlT PLAY button so that the lamp of the but-
ton turns off.
The current tlme wlli be
displayed
agaln.
To change t b preset atertlng
or
ending point belom
preeeing the EDIT START
button
Press the EDlT PLAY button once so that the lamp of
the button turns off, then repeat steps
1-3.
Notes
The II (pause), H (fast-forward) and
a
(rewlnd)
buttons wlli not tunctlon while the automatic m m -
bie editing is being canled out.
The preset starting and endlng polnts will be erased
if you turn off the power or elect the cassette.
YOU cannot set the endlng point at a point on the tape
that comes before the starting polnt.
With certaln other VCRs, the starting and endlng
points of the recordlng wlli
be
shifted a ilttie behlnd
the preset points.
he starllng/endlng
polnta
can ba selocled mom
ccurateiy uslng the JOO dial
w
the SHUTTLE dng
aefore pressing the MARK button In steps
2
andlor
3,
press the I I (pause) button. Then turn the JOG dlal
or SHUlTLE ring to piayback the deslred startlngl
ending point. The playback pause mode need not be
released to press the MARK button or the EDlT
START button.