Sony sl-hf600 Owner's Manual page 32

CAMERA RECORDING
CONNECTIONS
The camera must conform to American TV (EIA) stan-
dards.
The use of a Sony HVA-220 ac adaptor is required.
OPERATION
Set the INPUT SELECT switch to LINUPCM.
TO start recording, slide the REC switch to the right.
Once the recording is started, you can stop (pause) and
start the recording wlth the tape runlstop button on your
camera as well as wlth the I I (pause) button on the VCR
or on the Remote Commander.
To stop the recording completely, press the (stop)
button on the VCR or the camera.
FRAME-BY-FRAME SHOOTING
TO tape an animated program of your own, follow the
steps below.
1
Shoot an object, a doll for example, with your camera
for several seconds, then set the VCR in the record-
ing pause mode with the I I button.
.
2 Move the object a little and slide the REC switch of
the VCR to the right or press the record switch of the
Remote Commander.
A very short
recording
of approximately seven frames
wiil be made and then the VCR wlll automatically go
into the pause mode again.
Repeat Step 2 as many times as you like.
When such recordings are played back continuously,
the object wiil seem as If it is moving.
Notes
Thls functlon can also be used when recording from
the TV.
The picture may
be
a little distorted when the frame
by-frame recordlngs are played back.
If the VCR is kept in the pause mode for more than
about 8 mlnutes, the pause mode will be automatical-
32
ly released and the tape will stop.