Settings And Functions-450 Model; Wash Cycles; Pots/Pans; Normal Wash - Viking VDB325 Service Manual

Operation
Settings and Functions–450 Model
Control Operation
The following is the basic layout of the control panel and how it is referenced below.
Start Key

Wash Cycles

Pots/Pans

Heavily soiled pots, pans and casserole dishes. Long
heated pre-wash loosens up encrusted food. High
temperature main wash and final rinse.

Normal Wash

Normally soiled plates, glasses, bowls, and lightly
soiled pots and pans. Normal pre-wash, main wash
and rinse. Medium pressure and temperature.

Econo Wash

Normally soiled plates, glasses, bowls, and lightly
soiled pots and pans. Lower temperature main
wash and rinse. Longer pre-wash and main wash
to maximize cleaning performance while using less
energy.

Light/China

Lightly soiled dishes or fine china and crystal. Low
temperature wash and rinse. Lightest pressure to
protect dishes.

Rinse/Hold

All dishware. Short, medium pressure rinse with
no heat.
© 2011 Viking Preferred Service
Vari-Pressure Intelli-Wash
Quiet Clean System
Airflow Gentle Dry
POTS NORMAL SECOND LIGHT RINSE
PANS WASH WASH CHINA HOLD
Cycles

Options

Top Wash Only

Washes dishes on top rack only. Uses less water.
Conserves energy. Available on Normal Wash cycle.

Econo Dry

Selects a "no heat" dry. Available on Normal Wash,
Econo Wash and Light China cycles.
155° F (68° C) Final Rinse
Increases the temperature of final rinse to 155° F
(68°C). Available on Pots/Pans and Normal Wash
cycle.

Delay Start

Lets you delay running the dishwasher for up to
10 hours. To set DELAY START, select the desired
wash cycle and option(s). Press the "DELAY
START" button once and the number "2" will light,
indicating a two-hour delay. If you desire a longer
delay, continue pressing the "DELAY START"
button to a four, six, eight or ten hour delay. The
corresponding number on the button will light.
Once you have set the desired delay time, press the
"START" button and close the door. DELAY START
is not available with the Rinse/Hold cycle.
Turning Audible Sound On and Off
To turn off, press Rinse/Hold button for 10 seconds.
The beep stops and the Rinse/Hold LED will flash
two times. To turn on, repeat above instructions.
The audible sound beeps two times and the Rinse/
Hold LED flashes two times to identify that it is on.
Note: The audible sound cannot be disabled for
error messages.
Note: The LED will flash in sync with the audible
sound.
TOP ECONO 155˚ FINAL DELAY
WASH DRY RINSE START
Options
12