Door Disassembly; Outer Door Removal (325 And 450) - Viking VDB325 Service Manual

Service Diagnostics and Procedures–Disassembly

Door Disassembly

In order to gain access to the internal components
of the door, which includes the detergent dispenser,
start switch, door interlock, user interface and the
vent door (450 only), you will need to remove the
front door panel and the control panel.
CAUTION
Make sure that the outer door is held in place
while removing the screw so that the door
does not fall and become dented or scratched.
The inner door assembly is sharp and could
result in minor personal injury.

Outer Door removal (325 and 450)

In order to gain access to the inner door
components you must first remove the outer
stainless steel or wood door panel. Open the door
to a complete 90° angle to expose the securing
screws. Using a T15 TORX® screwdriver, remove
the four screws. These screws are 1"
( 2.5 cm) long.
© 2011 Viking Preferred Service
Screws
The following images show the actual location of
the screws.
Left Side
Note: When the outer door has been removed,
make sure to store it in a secure area until
reassembled, so it does not become scratched or
damaged.
Note: 325 Model shown.
Right Side
29