Settings And Functions; Control Operation; Wash Cycles; Pots / Pans - Viking FDB451 Service Manual

Settings and Functions

Control Operation

The following is the basic layout of the control panel and how it is referenced below.
VIKING
Start
Resume

Wash Cycles

POTS / PANS

Heavily soiled pots, pans and casserole
dishes. Long heated prewash loosens up
encrusted food. High temperature main wash
and final rinse.

NORMAL WASH

Normally soiled plates, glasses, bowls, and
lightly soiled pots and pans. Energy-usage
label is based on this cycle.

LIGHT/CHINA

Lightly soiled items, china and crystal. Lower
temperatures for cleaning delicate items.

FAST WASH

To remove light films and residue on dishes
and glassware. Short wash times and varying
pressures.

RINSE/HOLD

All dishware. Short rinse with no heat.

Options

HI TEMP WASH

Increases the temperature, adding heat,
time and water for improved cleaning
performance. Available only with POTS/
PANS and NORMAL WASH. Note: Periods of
soaking will occur to aid in removal of baked
on soils
©2012 Viking Preferred Service
• Vari-Pressure Intelli-Wash
• Quiet Clean System
POTS NORMAL
• Airflo Gentle Dry PANS WASH
LIGHT FAST RINSE CLEAN
CHINA WASH HOLD
CYCLES
SANITIZED 155˚F RINSE
Raises water temperature to 155˚F in the
final rinse. Adds heat and time to the cycle.
This high temperature rinse sanitizes your
dishes and glassware in accordance with
NSF/ANSI STANDARD 184 for Residential
Dishwashers. Certified for residential
dishwashers and not intended for licensed
food establishments. Available only with
POTS/PANS and NORMAL WASH.

DELAY START

Lets you delay running the dishwasher for up
to 10 hours. To set "DELAY START", select
the desired wash cycle and option(s). Press
the "DELAY START" button once and the
number "2" will light, indicating a two hour
delay. If you desire a longer delay, continue
pressing the "DELAY START" button to a
longer delay. The corresponding number on
the button will light. Once you have set the
desired delay time, press the "START" button
and close the door. "DELAY START" is not
available with the Rinse/Hold cycle.

AUDIBLE SOUND SIGNAL

A single beep will occur when you select
cycles, options and press the "START" key.
If the "START" button is not pressed or if
the door is not closed within 4 seconds of
pressing the "START" button, 3 short beeps
will occur. The end-of-cycle signal consists
of 2 long beeps and activates 30 minutes
after the last drain, when the condensate dry
portion of the cycle is completed. For all other
error messages and to deselect the audible
sound signal, see the Troubleshooting/ Fault
Codes section.
Operation
SANITIZED HI TEMP TOP SANITIZED
WASH WASH 155F RINSE
OPTIONS
2
4
DELAY
6
START
8
10
7