Operation; Settings And Functions; Control Operation; Wash Cycles - Viking VDB200 Service Manual

Operation

Settings and Functions

Control Operation

The following is the basic layout of the control panel and how it is referenced below.
Start Key

Wash Cycles

Pots/Pans

Heavily soiled pots, pans and casserole dishes. Long
heated pre-wash loosens up encrusted food. High
temperature main wash and final rinse.

Normal Wash

Normally soiled plates, glasses, bowls, and lightly
soiled pots and pans.

Econo/China

Normally soiled dishware, china and crystal. Lower
temperature wash cycle.

Rinse/Hold

All dishware. Short rinse with no heat.
© 2010 Viking Preferred Service
Cycles

Options

Hi Temp Wash

Increases the temperature of the main wash and
final rinse portions of the cycle. May add extra
water for improved cleaning performance. Available
on Pots/Pans and Normal cycles.

Delay Start

Lets you delay running the dishwasher for up
to four hours. To set DELAY START, select the
desired wash cycle and option(s). Press the "DELAY
START" button once and the number "2" will light,
indicating a two-hour delay. If you desire a longer
delay, continue pressing the "DELAY START" button
to a four-hour delay. The corresponding number on
the button will light. Once you have set the desired
delay time, press the "START" button and close the
door. DELAY START is not available with the Rinse/
Hold cycle.

Audible Sound Signal

A single beep will occur when you select cycles,
options and press the "START" key. The end-of-
cycle signal consists of two long beeps. If the
"START" button is not pressed or if the door is not
closed within four seconds of pressing the "START"
button, three short beeps will occur. For all other
error messages and to deselect the audible sound
signal, see Troubleshooting Guide, (page 36).
Options
10