Extra Period - A.O. Smith ADMR - 40 Installation, User And Service Manual

gis
Confirm with .
DAY TIME Tset
ON !SU 18:00 75ÉC P
OFF SU 22:00
ON MO 00:00 65ÉC P
OFF MO 23:59
....................
....................
OFF SA 23:59
INSERT
DELETE
START OPERATION
5. The lines showing switch-on/off times are replaced
by the text DELETE BLOCK?. See the figure.
Confirm with .
(or use to cancel)
DAY TIME Tset
ON ! DELETE
OFF BLOCK?
ON MO 00:00 65ÉC P
The switching period has been deleted. You will return
now to the week program menu. The cursor points to
the first programmed period.
DAY TIME Tset
ON »SU 08:15 75ÉC P
OFF SU 12:45
ON MO 00:00 65ÉC P
OFF MO 23:59
....................
....................
OFF SA 23:59
INSERT
DELETE
START OPERATION
to START OPERATION.
6. Scroll with
Confirm with .
The week program is active.

11.5 Extra period

Use an extra period when you either want to have the
appliance switch on and off for a certain period, either
without modifying the active week program, or without
taking the appliance out of the OFF mode (frost
protection active).
If the appliance is running under an "extra period",
then this is indicated in the display with the text
EXTRA.
EXTRA
10:00 Monday 76ÉC
MO 11:15 Tset 75ÉC
PERIOD ACTIVATED
Instruction manual ADMR
If the water temperature becomes too low during the
extra period (11.5.1 "Programming an extra period"),
the appliance will run through the heating
cycle (9.2 "The appliance's heating cycle") and fall
back into the extra period.
The same settings can be made for an extra period as
for a week program (11.4.2 "Changing the appliance's
standard week program") period.
11.5.1 Programming an extra period
1. Call up the menu for entering an extra period via:
2. : EXTRA PERIOD
Confirm with .
MENU
ON
^ WEEK PROGRAM
ȻEXTRA PERIOD
The display show the settings for the extra period.
Setting the switch-on time
1. Use and to set the day. In the example this is
SU.
Confirm with .
The cursor moves to the hour digits, which flash.
ON SU»00:00
OFF SU 00:59
Tset 65ÉC
PUMP ON START
2. Use and to set the switch-on hour to the
desired value. In the example, this is 08.
Confirm with .
The cursor moves to the minute digits, which flash.
ON SU 08»00
OFF SU 08:00
Tset 65ÉC
PUMP ON START
Note
Because the switch-off time can never be earlier
than the switch-on time, the switch-off time setting is
automatically adjusted with the switch-on time.
3. Use and to set the minutes. In the example,
this is 15.
Confirm with .
The cursor moves to the hour digits of the switch-
off period.
ON SU 08:15
OFF SU»08:15
Tset 65ÉC
PUMP ON START
59