Condition As Received, Installation - Dimplex VFMi 20 C Installation And Operating Instructions Manual

Hide thumbs

Table of Contents

Available languages

English

Condition as Received

The casing, heating element set and storage bricks are

supplied in individual packaging.

- The heating element set comprises the following

components:

- 3 heating elements,

- 1 heating element rating label,

- 1 charging knob,

- 1 screw, dowel, washer for tilt protection,

- 6 mounting screws for the wall spacers.

The wall spacers lie on top of the polystyrene frames of the

device packaging.

Please check the delivery for completeness. Complaints

about damage during transport are to be made according to

the instruction sheet. Minor damage to the storage bricks

does not affect device operation.

Installation

Storage heaters may not be used:

- In rooms with air that is potentially explosive,

- In rooms where corrosive air is to be expected.

The load-bearing capacity of the floor must be sufficient to

carry the weight of the heaters.

The installation surface must be smooth and level. The

devices can be installed on any conventional flooring,

however, the colour of PVC (linoleum) or parquet floor or

light-coloured carpeting can change in the area of the

supporting feet due to pressure and heat exposure. Wall or

carpet skirtings touching the rear panel of the device must be

removed.

Supporting boards (special accessories) must be

used:

- In case of heat-sensitive flooring, which cannot reliably

withstand temperatures of 176° F (80 ° C).

- If it can be expected that the supporting feet may sink into

the flooring, so that the air exchange below the storage

heater is obstructed.