It is absolutely forbidden
to use the third row seat
for transporting loads
when the seat back is tilted. Load
could be projected forward
against the seat back of the sec-
ond row seats thus causing in-
juries to passengers fig. 127a.
fig. 127a
To re-position the seat:
– seat back anchoring levers, both
right and left B-fig. 127 must be at 1
(released); otherwise move both
levers to position 1;
– raise first the seat back (without se-
curing it) then secure the entire seat
to the floor anchorings and then se-
cure the seat back.
Always check that seats
are anchored to the floor
before securing the seat
backs.
fig. 128
To remove the seat in order to in-
crease the boot space, tilt the seat and
remove the tool bag (keep it on the
vehicle) then use lever D-fig. 128 to
release catches.
Reverse the above operations for re-
fitting.
To increase the boot space you can
also tilt the second rear row as fol-
lows:
– tilt side seats (as described in para-
graph "access to the third row rear
seats");
fig. 129
GETTING TO KNOW YOUR VEHICLE
83