Fiat Doblo Owner's Handbook Manual page 136

2) Fit the wrench provided A-fig. 28
(used also to remove the wheel) to
the fastening bolt of the light unit.
3) Loosen the bolts, then undo the
light cluster fastening nuts by means of
extension B-fig. 28 supplied with the
unit.
As regards the 7-seater version is
concerned, undo the light cluster fas-
tening bolt by means of extension B-
fig. 28 inserted onto the bolt through
slotted hole C-fig. 28a.
4) Undo, after removing the fasten-
ing bolt, the cluster fastening screws
(located outside), as illustrated in
fig. 29.
fig. 28
fig. 28a
fig. 29
5) Take out the pressure-fit con-
nector.
6) Undo the four fastening screws to
remove the bulb holder and get access
to the bulbs.
7) Remove the bulbs fig. 30 by push-
ing them gently and turning them
counterclockwise (bayonet fitting)
A – brake light bulb
B – indicator light bulb
C – reversing light bulb
D – sidelight bulb
E – rear fog light bulb
fig. 30
IN AN EMERGENCY
135