Control Lockout - GE JCS905 Owner's Manual

Using the clock, timer and control lockout.
CLOCK
HORLOGE
Make sure the clock is set to the
correct time of day.
TIMER
MINUTERIE
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.

CONTROL LOCKOUT

9 0
VERROUILLAGE CONTROLES
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Press the TIMER pad.
Press the number pads until the
amount of time you want shows in
the display. For example, to set 2
hours and 45 minutes, press 2, 4
and 5 in that order.
If you make a mistake, press the
TIMER pad and begin again.
Press the START pad.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the TIMER pad, then press the number
pads until the time you want appears in
the display.
To Cancel the Timer
Press the TIMER pad twice.
Control Lockout
Your control will allow you to lock out the press
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Press the 9 and 0 pads at the same
time for 3 seconds, until the display
shows LOC ON.
To unlock the control, press the
9 and 0 pads at the same time for
3 seconds, until the display shows
LOC OFF.
www.GEAppliances.ca
Press the CLOCK pad.
Press the number pads.
Press the START pad.
After pressing the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the TIMER pad is pressed.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time
by pressing the TIMER pad and then
pressing the number pads to enter the
new time you want.
When this feature is on and the press
pads are pressed, the control will beep
and the display will show LOC ON.
I
The control lockout mode affects all press
pads. No press pads will work when this
feature is activated.
I
The adjustment will be retained in memory
after a power failure.
13