Installing An Expansion Card - Dell DSS 1500 Owner's Manual

Figure 24. Removing and installing the expansion card from expansion card riser
1. expansion card riser
3. expansion card
Next steps
Follow the procedure listed in

Installing an expansion card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Locate the expansion card connector on the riser.
2. Holding the card by its edges, position the card so that the card edge connector aligns with the
connector on the expansion card riser.
3. Insert the card edge connector into the expansion card connector until the card is firmly seated.
NOTE: Ensure that the expansion card is properly seated along the chassis, so that expansion
card latch can be closed.
4. If applicable, connect the cables to the expansion card.
5. Install the expansion card riser on the system board.
Next steps
Follow the procedure listed in
After working inside your
Safety instructions.
Before working inside your
After working inside your
2. expansion card latch
system.
system.
system.
65