Hard Drives - Dell DSS 1500 Owner's Manual

Figure 15. Installing the memory module
1. memory module
3. memory module socket ejector (2)
When the memory module is properly seated in the socket, the levers on the memory module socket
align with the levers on the other sockets that have memory modules installed.
5. Repeat steps 1 to 4 of this procedure to install the remaining memory modules.
Next steps
1. If removed, reinstall the PCIe expansion card riser.
2. Reinstall the cooling shroud.
3. Follow the procedure listed in
4. Press F2 to enter System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the installed memory.
5. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat
steps 2 and 3 of Removing a memory module
modules are firmly seated in their sockets.
6. Run the system memory test in the system diagnostics.
Related Tasks
Installing the cooling shroud
Entering System Setup
Using system diagnostics

Hard drives

Depending on the configuration, your system supports one of the following:
50
After working inside your
procedure, checking to ensure that the memory
2. alignment key
system.