Table of Contents
Advertisement
EASYINSTALL CONNECTIONS
PEX tubing with 3/8˝ compression
fitting
PEX tubing has a 95-year spec life.
Fits American dishwasher water
supply valves. Be sure to install the
O-Ring which is attached to the PEX
tubing in a plastic bag
Drain hose boot
Ready to be cut to desired
drain connection. Only
one clamp required.
WATER SUPPLY
WARNING!
Plumbing connections must comply with applicable
sanitary, safety and plumbing codes in your area.
The machine can be connected to either a hot (max. 160
°F, 70 °C) or cold water supply. We recommend a cold
water supply. The water pressure should be 4.2-140 psi.
Connect to cold water...
If you use oil or electricity to heat your home.
Connect to hot water (max 160 °F, 70 °C)...
If you use district heating, solar power, or geothermal
power to heat your home. Choosing a hot water
connection cuts program times and reduces the
dishwasher's electricity consumption.
Page 4
Electrical cord
120 volts, 15 amp cord is supplied with
the dishwasher.
WARNING!
Risk of electric shock. Do not use an extension cord
for this appliance.
The dishwasher comes with a 6-foot PEX water supply
line that has a 3/8˝ NPT female connection.
After determining where the water supply line will enter
under the sink, drill a 1-1/2˝ (38 mm) access hole and
run the line to the approximate inlet valve location shown
in the figure below. The water line inlet valve is on the
right rear of the machine.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location, such as, beneath the sink.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At least 3 gallons
(12 liters) per minute must be able to pass through the
line. The water pressure should be 4.2-140 psi.
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
(1) Water supply
(2) Water supply valve to dishwasher (not supplied)
NOTE:
Be sure to run the PEX tubing through the hole to the
sink compartment before moving the dishwasher into
position.
Customer Care Center
1-800-898-1879
www.askona.com
Advertisement
Table of Contents
