Connecting Devices To The Server - Fujitsu PRIMERGY RX2530 M1 Operating Manual

5.3

Connecting devices to the server

The connectors for external devices are on the front and rear of the server. The
additional connectors available on your server depend on the expansion cards
installed.
I
Some of the devices that can be connected may require special
software, e.g. drivers (see the documentation for the connected device).
Figure 2: Ports on the front
The following connectors are located on the front of the server:
1 2 x USB 3.0 connectors
A front VGA connector is available as an option.
10 HDD variant
For the variant with 10 HDDs of the PRIMERGY RX2530 M1 there is an
USB 2.0 connector on the front panel on QRL instead of above mentioned
USB3.0 connectors.
Figure 3: Front panel on QRL
1 1 x USB 2.0 connector
RX2530 M1
Operating Manual
Hardware installation
51