Table of Contents
Advertisement
Remote Control Configuration for AV devices
To eliminate the amount of remote controls you need, this remote control will operate the main functions of
some Sony's DAV, Sony's AV receivers as well as Sony's STB (see the table on the following page with the
available devices).
To operate these devices with this remote needs to be configured.
To do this:
fig. 2
• Before you start, look up the 3digit code of your device from the list on the following page.
• A small label is added inside the battery door to allow you to record your brand codes.
• Sony will endeavour to update the software according to market changes. Therefore, please
refer to code table included with the remote control for latest code set.
1
Press and hold the
seconds until the green AUX light of the Media Selector starts flashing (see
fig. 1).
2
While the AUX light is flashing, enter the three digits of the code for your
device (see the list on the following page) using the number buttons on
the remote control.
3
Turn on your device and check that the main functions work (see the table
on the following page to check the main functions according each
equipment).
4
Always remember to press
equipment you want to operate with this remote control: TV or AUX. Refer to page 27 on how
to operate the VCR and DVD modes.
28
Additional Information
t
button of the remote control for approximately 6
If your selected code is entered correctly, the green AUX light will
be lit momentarily (see fig. 3), otherwise repeat all the above steps.
• If your device is not working or some of the functions do not work, please check that you
entered the correct code set.
T
t
or
button until the green light illuminates according to the
fig. 1
MODE
6 sec.
fig. 3
MODE
continued...
Advertisement
Table of Contents
