Dish Network ViP622 User Manual page 84

Checking the Remote Control Address
1
Press and hold the SAT mode button a few seconds until all of the mode buttons light up,
then release SAT.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (for example, three flashes means address 3).
Confirming Remote Control Operation
1
Make sure the remote control has fresh batteries installed and is in SAT mode.
2
Press the SYSTEM INFO button on the receiver's front panel to display the System
Information screen on the nearby TV.
3
Press and release the RECORD button on the remote control:
• Remote Control 1—The Primary Remote Address in the System Information screen
changes to match the address preset in your TV1 remote control. Typically, the remote
control for the nearby TV is set to IR only, unless you have received an IR/UHF Pro
remote control replacement kit.
• Remote Control 2—The Secondary Remote Address in the System Information
screen changes to match the address preset in your TV2 remote control. Odd-
numbered remote addresses will automatically use UHF Pro Band A, while even-
numbered addresses will use UHF Pro Band B. If you have two UHF Pro remote
controls in your home, ensure that one uses an odd-numbered remote address and
the other an even-numbered address. If you have more than two DISH Network
remote controls, then consult the SYSTEM INFO screen on each of the receivers to
ensure that all the IR/UHF Pro remote controls use different remote addresses.
4
Select Done to close the System Information screen.
5
Press the POWER button on the remote control to turn the receiver on or off (standby).
Remote Controls
Improving Receiver Control
75