Dish Network ViP622 User Manual page 117

Chapter 12
Connecting to the Remote TVs (TV1 or TV2)
Note: The remote TV(s) will have to be set to the same channel mode, either air or cable
channel mode for this installation. See your TV user's guide for instructions on how to set
your TV to air or cable channel modes.
4
Pick the channel in the middle of the three you selected in step 3. Write that channel down
in the blank provided in step 5. For example, if the three channels you picked in the
preceding step were air channels 60, 61, and 62, pick channel 61 and write it in the space
provided in step 5.
5
If your TV is in over-the-air mode for the channels you picked in step 4, circle "Air" below.
If your TV is in cable mode for the channels you picked in step 4, circle "Cable" below. If
you are using these instructions for TV1 and TV2, pick different channels (for example,
Channel 60 for TV1 and Channel 64 for TV2).
TV1 Channel:
6
Set all of your remote TV(s) to the channel mode (air or cable) you wrote in step 5.
7
Tune all of your remote TV(s) to the channel(s) you wrote in step 5. This is the channel
you will use to receive your satellite programming.
8
Connect CH 21-69 O
cable.
Note: If you do not have an existing in-home cable system, you will need to run coaxial
cable to each TV in other rooms. If this is too difficult, you may want to contact a
professional to do this installation.
9
Place the yellow sticker on the CH 21-69 Out cable near where the cable attaches to the
receiver. The stickers are located inside the front cover of this guide.
10
Turn on the nearby TV (the TV that gets programming from the TV1 outputs).
11
Make sure the receiver's green TV1 indicator is on.
12
Press MENU. Select System Setup, Installation, and then Modulator Setup.
13
With the Modulator Setup screen displayed on the nearby TV, use Remote Control 1 to do
the following:
a
Under TV2 Out (or TV1 Out), select either Air (air channel numbers) or Cable (for
cable channel numbers) based on what you wrote down in step 5.
b
Under TV2 Out (or TV1 Out), use the UP and DOWN ARROWS to change the
modulator channel to the one you wrote in step 5.
c
Select Done.
Note: For TV1 O
enter your password.
14
For some TVs, you must run a channel scan so that the TVs will find and display the
selected channel from the receiver. Run the channel scan on all remote TVs, if available.
See your TV user's guide for instructions.
108
TV2 Channel:
on the receiver to your existing wall cable outlet using a coaxial
UT
, if you locked the receiver, a message will display asking you to
UT
Air/Cable