Eliminating Shadows Or Streaks On The Scanned Image Edge [Page Edge Filler (Automatic Page Size Detection)] - Fujitsu fi-6800 Operator's Manual

Chapter 8 Operational Settings
Eliminating Shadows or Streaks on the Scanned
Image Edge [Page Edge Filler (Automatic Page
Size Detection)]
When scanning in Automatic Page Size Detection, depending
on the condition of the document that you scan, some shadow
of the document may be reflected onto the edge of the output
image and appear as black streaks.
In this case, you can improve the image quality around the
edges by using the Page Edge Filler function to fill around the
edges.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2] 
[Page Edge Filler (Automatic Page Size Detection)].
3
Specify the width of each margin to fill; top, bottom, right,
and left.
T
L Image
area
B
The specified area is filled in the same color as the background.
Note that if the target range of the Page Edge Filler is

132).
too wide, some characters near the edge may be cut
out.
Unless Automatic Page Size Detection is specified, the

setting of [Page Edge Filler (ADF)] is applied. For more
details, refer to
the Scanned Image Edge [Page Edge Filler (ADF)]"
(page
This setting can also be configured from the scanner

driver's setup dialog box. Note that priority is given to
the setting with the larger value.
This setting does NOT appear when Kofax VRS

(optional) is used.
T :Top = 0 to 7.5 mm
B :Bottom = 0 to 7.5 mm
R :Right = 0 to 7.5 mm
R L :Left = 0 to 7.5 mm
(in 0.5 mm increments)
"Eliminating Shadows or Streaks on
151).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
152