Ricoh G157 Service Manual page 128

INCORRECT PRINTOUT
Unable to print all pages of a document and the "PRINT OVERRUN"
P-2
message appears.
1. Press the Black Start key on the operation panel to print the data remaining in
the machine.
2. If this does not clear the error, reduce the complexity of your document or
reduce the machine resolution.
3. Change the following setting in the machine driver and try again. The best
combination of settings below will vary depending on your document.
• Graphic Mode/ TrueType
NOTE: This problem may appear if the data is too complex. If it is not cleared by
taking the actions above, it will be impossible to print such data under the
machine specifications.
Unable to print all pages of a document and the "MEMORY FULL"
P-3
message appears.
1. Press the Start key on the operation panel to print the data remaining in the
machine.
2. Reduce the complexity of your document or reduce the machine resolution.
NOTE: This problem may appear if the data is too complex.
Possible cause
Controller board
failure
Headers or footers are not printed out, but they can be seen on the
P-4
PC screen.
1. Most laser printers have a restricted area that cannot be printed on. Usually the
first two lines and last two lines of text cannot print (leaving 62 printable lines).
2. Adjust the top and bottom margins in your document to allow for this.
G157
TM
mode
Step Check
1 Is it possible to print
after reducing the data?
Result
Yes
4-38
Countermeasure
Replace the BCU and/or
controller.
SM