Wap6806 Access And Login - ZyXEL Communications ARMOR X1 User Manual

15.2 WAP6806 Access and Login

I forgot the password.
The default password is 1234.
1
If this does not work, you have to reset the device to its factory defaults. See
2
page 82.
I cannot see or access the Login screen in the Web Configurator.
Make sure you are using the correct address.
1
• The default web address (URL) of the WAP6806 is http://zyxelsetup or http://
192.168.1.2.
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
2
Start Guide.
Make sure your Internet browser does not block pop-up windows and has JavaScript and Java
3
enabled.
Reset the device to its factory defaults, and try to access the WAP6806 with the default address.
4
If the problem continues, contact the network administrator or vendor, or try one of the advanced
5
suggestions.
Advanced Suggestions
• If your computer is connected wirelessly, use a computer that is connected to a ETHERNET port.
I can see the Login screen, but I cannot log in to the WAP6806.
Make sure you have entered the password correctly. The default password is 1234.
1
This can happen when you fail to log out properly from your last session. Try logging in again after
2
5 minutes.
Disconnect and re-connect the power adaptor or cord to the WAP6806.
3
If this does not work, you have to reset the device to its factory defaults. See
4
86.
Chapter 15 Troubleshooting
WAP6806 User's Guide
84
Section 14.5.3 on
Section 15.4 on page