Rustic Log Set Installation/Removal - Pacific energy BROADWAY Installation And Operating Instructions Manual

INSTALLER
INFORMATION
Installation
1. Position rear logs #1 and #2 against the back
firebox as seen in Figure 48.
2. Position front logs #3 and #4 between the front
burner tubes as seen in Figure 49.
3. Position side logs #5; #6 as seen in Figure 50.
4. Position logs #7 and #8 as seen in Figure 51.
5. Place logs # 9; 10 and 11 and ember chunks in
front of burner to hide the burner as seen in
Figure 52.
Note: Do Not Block Burner Ports with
Embers
Removal
1. Remove embers from fireplace.
2. Lift the side and decorative log off of the front
log and remove it from the firebox.
3. Lift the front logs off of the burner and remove
it from the firebox.
4. Lift the rear logs over the pilot and burner and
remove from firebox.
Figure 49: Front Log Installation
Figure 51: Decorative Log Installation
020215-36
Rustic Log Set Installation / Removal
Figure 48: Rear Log Installation
Figure 50: Side Log Installation
Figure 52: Complete Log Set
28
Figure 47: Log Set
5055.66-E