Stihl 088 Owner's Manual page 30

• Screw the spindle fully into
service tool ZS (2) and then
screw the threaded sleeve (1)
5910 893 2421 onto the spindle
as far as it will go.
- Lubricate tapered crankshaft
stub with oil.
• Place tapered crankshaft stub in
ball bearing at starter side of
crankcase.
• Apply threaded sleeve (1) to
thread (2) on crankshaft stub
and screw it on.
STIHL 088
• Hold the spindle steady and turn
the service tool counterclockwise
until the drilled plate butts against
the crankcase.
• Turn the spindle clockwise the
until the crankshaft locates
against the ball bearing.
Important: The connecting rod must
point toward the cylinder flange
while the crankshaft is being
installed.
• Release the spindle by turning it
counterclockwise and then hold the
crankshaft steady and unscrew the
service tool counterclockwise.
• Fit a new gasket on the clutch
side of the crankcase.
- Lubricate straight crankshaft
stub with oil.
• Position crankshaft stub in ball
bearing.
30