Stihl 088 Owner's Manual page 29

- Heat area of bearing seat on
starter side of crankcase to approx.
150° C (300°F).
• Place ball bearing in position
(closed side up) and push it home
by hand as far as stop.
Note: This operation must be carried
out very quickly because the bearing
absorbs heat immediately and begins
to expand.
• If it is not possible to heat the
crankcase, use the press arbor
(1) 1124 893 7200 to press in the
ball bearing as far as stop.
STIHL 088
• After the crankcase has cooled
down, push the annular buffer into
position until its annular groove (1)
engages the edge of the housing
(2).
C:\WINNT\Profiles\Administrator\Startmenü;
C:\WINNT\Profiles\Administrator\Startmenü;
• Place filler cap's cord (1) in the
groove (2) and pull it forward.
• After the crankcase has cooled
down, push the stop buffer into
guide until its lugs are behind the
edge of the housing.
• Push the two annular buffers,
tapered end first, into position
until their annular grooves (1)
engage the edge of the housing
(2).
• Push the oil suction hose into the
crankcase bore.
• Use a blunt tool to push the oil
suction hose into the bore so that
its tab locates in the recesss at the
top left.
29