Conventional Cruise Control Mode Failure Warning - Toyota sienna 2004 Service Manual

RESUMING THE PRESET SPEED
If the preset speed is cancelled by pulling
the lever, by depressing the brake pedal
or by activating the vehicle stability con-
trol system, pushing the lever up in the
"+ RES" direction will restore the speed
set prior to cancellation.
However, once the vehicle speed falls be-
low about 40 km/h (25 mph), the preset
speed will not be resumed.
CONVENTIONAL CRUISE CONTROL
MODE FAILURE WARNING
If there is trouble in the conventional
cruise control mode, the "CRUISE" indica-
tor light in the instrument cluster flashes,
the master warning light comes on and
the alarm sounds, the warning code "E3"
will appear on the display.
If a system malfunction is detected when
the conventional cruise control mode is in
the ready mode or operating, the master
warning light comes on, an alarm sounds
and the above code appears.
210
04 SIENNA_U (L/O 0408)
If this code appears, press the "ON−OFF"
button to turn the system off and then
push it again to turn it on. If the setting
still cannot be made or the same code
appears again, the system might have
malfunctioned. Although there is no prob-
lem to continue driving, please contact
your Toyota dealer.
I n f o r ma t i o n P r o v i d e d b y :
2004 SIENNA from Aug. '04 Prod. (OM45422U)