Automatic Transaxle; Rear Differential; Brakes - Toyota sienna 2004 Service Manual
Hide thumbs
Also See for sienna 2004:
- Maintenance and care (6 pages) ,
- Operating manual (490 pages) ,
- Owner's manual (505 pages)
Table of Contents
Advertisement
With ethylene−glycol type coolant for a
proper corrosion protection of aluminum
components
Do not use alcohol type antifreeze or
plain water alone.
Please contact your Toyota dealer for
further details.
BATTERY
∗
Open voltage
at 20_C (68_F):
12.6—12.8 V
Fully charged
12.2—12.4 V
Half charged
11.8—12.0 V
Discharged
∗
: Voltage that is checked 20 minutes af-
ter the key is removed with all the
lights turned off
Charging rates:
5 A max.
AUTOMATIC TRANSAXLE
Fluid capacity (drain and refill), L (qt.,
Imp. qt.):
Two−wheel drive models
3.5 (3.7, 3.1)
All−wheel drive models
3.6 (3.8, 3.2)
Fluid type:
Toyota Genuine ATF Type T−IV
Change automatic transmission fluid only
as necessary.
490
04 SIENNA_U (L/O 0408)
Generally,
it
is
necessary
to
change
automatic transmission fluid only if your
vehicle is driven under one of the Special
Operating
Conditions
listed
in
"Scheduled
Maintenance
Guide"
"Owner's
Manual
Supplement".
When
changing the automatic transmission fluid,
use only "Toyota Genuine ATF Type T−IV"
(ATF JWS3309 or NWS6500) to aid in
assuring optimum transaxle performance.
Notice: Using automatic transmission
fluid other than "Toyota Genuine ATF
Type T−IV" may cause deterioration in
shift quality, locking up of your trans-
mission accompanied by vibration, and
ultimately damage the automatic trans-
mission of your vehicle.
Please contact your Toyota dealer for fur-
ther details.
TRANSFER
(all−wheel drive models)
Oil capacity, L (qt., Imp. qt.):
0.9 (1.0, 0.8)
Oil type:
Hypoid gear oil API GL−5
Recommended oil viscosity:
Above −18_C (0_F)
SAE 90
Below −18_C (0_F)
SAE 80W or 80W−90
I n f o r ma t i o n P r o v i d e d b y :
REAR DIFFERENTIAL
(all−wheel drive models)
Oil capacity, L (qt., Imp. qt.):
your
0.9 (1.0, 0.8)
or
Oil type:
Hypoid gear oil API GL−5
Recommended oil viscosity:
Above −18_C (0_F)
SAE 90
Below −18_C (0_F)
SAE 80W or 80W−90
BRAKES
Minimum pedal clearance when depressed
with the force of 490 N (50 kgf, 110 lbf)
with the engine running, mm (in.):
52 (2.0)
Pedal free play, mm (in.):
1—6 (0.04—0.24)
Pad wear limit, mm (in.):
1.0 (0.04)
Lining wear limit, mm (in.):
1.0 (0.04)
Parking brake adjustment when depressed
with the force of 294 N (30 kgf, 66 lbf):
3—5 clicks
Fluid type:
SAE J1703 or FMVSS No.116 DOT 3
2004 SIENNA from Aug. '04 Prod. (OM45422U)
Advertisement
Table of Contents
