Checking And Adding Power; Steering Fluid; Bleeding Power Steering System - GMC chervolet camaro 1999 Service Manual

· 2-24 Power Steering System
Checking and Adding Power
Steering Fluid
Steering
Notice: When adding fluid or making a complete fluid
change, always use the proper fluid. Failure to use
the proper fluid will cause hose and seal damage and
fluid leaks. Refer to Power Steering Fluid
Recommendations in this section.
The fluid level is indicated by marks on the fluid level
indicator. The fluid level indicator is located on the
reservoir cap.
• If the fluid is about 77°C (170°F), the fluid level
should be at the H mark.
• If the fluid is about 21 °C (70°F), the fluid level
should be at the C mark.
Bleeding Power Steering System
Bleed Procedure
Tools Required
• J 35555MityVac
• J 43485 Power Steering Bleeder Adapter
• Bleed the steering system for the following reasons:
- Components replaced
- Fluid line disconnected ·
- Steering system noise occurs
- Prevention of pump damage
- Proper system operation (
Important: Use clean, new power steering fluid
type only.
• See the Maintenance Lubrication subsection for
fluid specifications.
443639
Important: Hoses touching the frame, body or engine
can cause system noise.
443641
• The hoses must not touch any other part of
the vehicle.
Important: Loose connections may not leak, but could
allow air into the steering system.
• Verify that all hose connections are tight.