Sony Bravia KLV-40ZX1 Operating Instructions Manual page 6

6
Attach the stand cover.
Hang the stand cover over the top of the
Table-Top Stand's centre post, and then
push down to close until it clicks.
~
• Be sure not to pinch the AC power cord when
attaching the cover.
7
Attach the terminal cover.
8
Connect the TV to your AC power outlet
(110-240V AC, 50/60Hz).
Removing the Table-Top Stand
If the monitor is to be wall-mounted, remove
the Table-Top Stand.
1
Place the monitor face down.
Lay a mat (packing sheet, etc.) on a table
wider than the monitor, then place the
monitor on the table with the stand
hanging over the edge of the table. Be
sure to work with two or more people.
Packing sheet, etc.
6
GB
to AC power outlet
to AC power outlet
2
Remove the four screws from the Table-
Top Stand.
~
• Do not use the screws removed from the
Table-Top Stand for the Wall-Mount
Bracket.
• When you carry the monitor, move the
monitor with a mat laid below.
• Hold the Table-Top Stand firmly with both
hands.
Installing on a wall
Prepare the following items;
– SU-WL700 Wall-Mount Bracket (not supplied)
– SS-WAL700 Speaker System (not supplied)
– Spacers (black) (4) (supplied)
For 4-2 to 4-7 and 5-1 in the following
steps, refer to the corresponding part of the
instruction manual supplied with the Wall-
Mount Bracket.
1
Place the supplied spacers (4-2).
Screw
Spacer
Remove the four screws from the rear of the
1
monitor.
Place the spacers (black) on the screw holes
2
of the previous procedure.