Sony Bravia KLV-40ZX1 Operating Instructions Manual page 34

IR Blaster Set-up
HDMI Set-up
Product Information
Factory Settings
Monitor Set-up
See the "Monitor Set-up" setting for monitor (page 42).
34
GB
Dual Sound Selects the sound from the speaker for a stereo or bilingual
broadcast.
Stereo/Mono
Main/Sub/Mono For a bilingual broadcast, select "Main"
z
• If you select other equipment connected to the unit, set
"Dual Sound" to "Stereo", "Main" or "Sub".
See page 12 for the "IR Blaster Set-up" setting.
This is used to set the "Control for HDMI" compatible equipment connected to the
HDMI jacks. Note that the interlock setting must also be made on the connected
"Control for HDMI" compatible equipment side.
Control for HDMI This sets whether to interlock the "Control for HDMI"
compatible equipment and the unit. When set to "On", the
following menu items can be performed. However, power
consumption in standby mode is higher than usual. If the
specific Sony equipment that is compatible with "Control for
HDMI" is connected, this setting is applied to the connected
equipment automatically when the "Control for HDMI" is set
to "On" using the unit.
Auto Devices Off When this is set to "On", the "Control for HDMI" compatible
equipment turns off when you switch the unit to standby
mode using the remote.
Auto TV On
When this is set to "On" and if the connected HDMI control
compatible equipment is turned on, the unit automatically
turns on, and the displays the HDMI input from the
connected equipment.
Device List
Creates or updates the "HDMI Device List". Up to 14
Update "Control for HDMI" compatible equipment can be
connected, and up to four equipment can be connected to a
single jack. Be sure to update the "HDMI Device List" when
you change the "Control for HDMI" compatible equipment
connections or settings. Select them manually one by one
until getting a correct picture for several seconds.
HDMI Device List Displays the connected "Control for HDMI" compatible
equipment.
Displays your media receiver's product information.
Select "Monitor Product Information" to display your monitor's product
information.
Resets all settings to factory settings except for the "Remote Control Set-up"
setting, "Programme Block" setting, "Favourites" setting, and programme preset
data. After completing this process, the initial set-up screen is displayed.
Completing auto tuning in initial set-up will reset the settings that are not reset by
"Factory Settings". To retain the settings, select "Cancel" in the auto tuning
confirmation dialog.
z
• Be sure not to turn the unit off during this period (it takes about 30 seconds) or
press any buttons.
For a stereo broadcast.
for sound channel 1, "Sub" for sound
channel 2, or "Mono" for a mono
channel, if available.