Planet VC-201A User Manual page 28

3.3.2 Connecting Multiple PCs to an Ethernet LAN
Refer to the following procedures to setup the VC-202A to an
Ethernet LAN.
1. Set the VC-202A to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the VC-202A by connecting its power source.
3. Power LED will illuminate.
4. Connect coaxial cable from another VDSL device to VDSL BNC
port of the VC-202A.
5. LNK LED will illuminate.
6. Connect Ethernet port to Ethernet Switch (or Broadband
Router) via regular Cat. 5, 5e or 6 cables.
RG58 Jack
Figure 3-7: Connecting Multiple PCs to an Ethernet LAN
Please refer to your Ethernet device User's Manual
for the device's set up information.
Note
2
VC-202A
VDSL
BNC
TP
VDSL2
RG58 / RG6
VDSL2
RJ-45
Cat.5 Twisted Pair Cable
Fast Ethernet
Switch
100Base-TX UTP
VDSL2 Coaxial Cable
b/g b/g