Cutting Unit Switches; Variable Cylinder Speed; Backlapping Lever - Ransomes Highway 2130 Safety And Operation Manual

6 CONTROLS
GB

6.10 CUTTING UNIT SWITCHES

To commence cutting ensure speed limiter is in
mow position and the cylinders have been lowered
Push bottom of the rocker switch (N) and depress
foot switch (B) Push top of rocker switch to stop
cutter unit rotation. (Cutting units stop rotating
automatically when raised.)
NOTE: The backlapping lever must be in the
drive position before cylinders wil rotate.

6.11 VARIABLE CYLINDER SPEED

The speed of rotation of the cutting cylinders is
adjustable by means of the handwheel (A) situated on
the left hand side of the operator. Cylinder speed
should be set to maximum in normal cutting conditions.
In very long growth conditions, cylinder speed should
be reduced to obtain best finish,cylinder speed should
also be reduced when cutting very short, dry grass to
prevent excesive cylinder and bottom blade wear.
Rotate the hand wheel clockwise to increase cylinder
speed, anticlockwise to decrease cylinder speed.

6.12 BACKLAPPING LEVER

The lever (B) sets cutting cylinder rotational direc-
tion with three positions:
(a) fully towards the seat for mowing, (b) fully away
from the seat for backlapping and (c) set in the mid
position for neutral. See the separate cutting unit
operator's manual for an explanation of the
backlapping procedure.
GB-14
RANSOMES HIGHWAY 2130
SAFETY AND OPERATORS MANUAL