Hydraulic Lift Levers; Cutting Unit Switches - Ransomes HR3806 Safety And Operation Manual

6 CONTROLS
6.8

HYDRAULIC LIFT LEVERS

The cutting unit can be raised and lowered by
control lever (A) situated on the right hand side of
the operators seat and can be operated as follows:
NOTE: If the unit is raised out of work then lowered into
work again the blade will not rotate until the mow foot
switch is depressed.
To lift: Move the lever backwards and hold in position
until the unit is at the required height.
To lower: Move the lever fully forwards and release, the
unit will lower to ground level. DO NOT hold lever in
forward position.
NOTE: The unit will only lift and lower when the engine
is running.
IMPORTANT: If, when cutting, the lift control lever is
accidentally pulled back, the cutting unit will not float
over ground undulations until the lever is pushed fully
forward and allowed to return to neutral again.
6.9

CUTTING UNIT SWITCHES

To commence cutting ensure speed limiter is in
mow position and the units have been lowered.
Push bottom of the rocker switch (G) and depress
foot switch (A) Push top of rocker switch to stop
cutter unit rotation. (Cutting unit stop rotating
automatically when raised.)
GB-14
RANSOMES HR3806 Series: DZ
SAFETY AND OPERATORS MANUAL